Curd & Rind A home cheesemaking ledger: every make, every parameter, every rind.

Ledger / Hard / 2026-10-27

Pecorino Romano: Dry-Salted at 3.5% and Aged in a Dry Cave

Romano is the only cheese here that is dry-salted rather than brined, and the rate is high: 3.5% over three applications. Sheep milk takes salt readily, so a brine would overshoot. The dry cave at 75% humidity is what keeps the paste from going soft under all that salt.

Set 25′ 34 °C
Cut 12′ 6 mm
Scald 30′ 48 °C
Drain 30′ pH 6.1

Each segment is as wide as its share of the 97 minutes in the vat; the set segment carries the set temperature, the cut segment carries the cut size.

Salt and press drawer
Salt methodDry salt rub
Dry salt3.5 %
Press40 kg × 16 h

Press ladder

  • 12 kg1 h
  • 25 kg5 h
  • 40 kg10 h

Fine salt rubbed into the surface at 8-12 g per kg, repeated until the salt stops disappearing.

Cut face and rind figure: Pecorino Romano: Dry-Salted at 3.5% and Aged in a Dry Cave
The cut face is one irregular polygon whose vertex count is set by the 30% target moisture; the pores are countable negative space, and the rind arcs increase with the 240-day cave.

A 48 C cook, not 55

Sheep milk at 1.2% thermophilic culture, 34 C, twenty-five minutes of ripening, 30 IMCU of calf rennet per litre, twenty-five minute set. Cut to 6 mm and heat to 48 C over thirty minutes.

Forty-eight is the right number for sheep milk. It is already high in solids and a 55 C cook makes the curds so dry that they will not knit under the press, leaving a wheel that crumbles at the rim.

Dry-salt in three applications

Press at 12 kg for an hour, 25 kg for five hours, 40 kg for ten. Then rest two days and dry-salt: 1.2% of the wheel weight on day one, rubbed over the whole surface.

Then 1.2% again on day three and 1.1% on day six. Each application goes on after the previous one has been fully absorbed and the surface has dried. Salting wet-on-wet builds a crust that traps moisture and the wheel goes soft in the middle.

Fourteen degrees and 75% - drier than any other cave here

Age at 14 C and 75% RH, turning daily for the first month and twice a week after. Seventy-five percent is the driest cave in this ledger, and it is what stops a cheese carrying 3.5% salt from sweating.

If your cave sits at 85%, the rind will stay damp and develop a sticky orange film under the salt crust. Wipe it off with a dry cloth and drop the humidity; do not wash it with brine, which adds more salt.

Eight months, and grate it rather than eat it

At eight months the cheese is hard, sharply salty, and intensely savoury with a pronounced sheep-milk tang. It is not a table cheese at that point in the way a Manchego is; it is a grating cheese and it is very good at that.

If you want it eatable, cut a wheel at five months and keep it wrapped at 8 C. At five months the salt is still forward but the paste is firm and sliceable, and it is a much better cheese on a board than most people expect from a Romano.


Aging parameters

MilkSheep milk 6.5% fat
CultureThermophilic 38–45 °C
RennetCalf rennet (animal) 30 IMCU/L
pH at drain6.1 target 6.1–6.5
Target moisture30 %
Cave temperature14 °C
Cave humidity75 %
Aging days240 days
Rind treatmentDry salt rub
Yield4.2 kg

Sheep milk Hard 240 days


Defect diagnosis

Flagged on this make: Bitterness、Misread surface mould

Bitterness seen this make

Signal — A harsh, lingering bitter note at the back of the palate, strongest in the first three weeks and often fading after six.

Cause — Too much rennet for the set time, or a microbial coagulant with high protease activity, or a scald that never got past 38 C.

Fix — Cut the dose by 20% next make and hold the scald 2 C higher for 10 minutes longer. Bitter peptides are water-soluble, so a 12% brine for 24 hours pulls some out.

Rancidity not seen

Signal — Soapy, paint-like smell that hits before the cheese reaches the mouth. Sharp and unpleasant rather than merely strong.

Cause — Free fatty acids released by lipase, usually from raw milk that sat warm too long, or from rennet paste, or from a knife or cloth that carried old milk residue.

Fix — Chill milk to 4 C within two hours of milking and pasteurise anything older than 24 hours. Retire the cloth: boil it, do not just rinse it.

Faulty eye formation not seen

Signal — Either no eyes where the style demands them, or a scatter of irregular slits and cracks instead of round, evenly spaced holes.

Cause — Coliform or yeast contamination from unsanitary brine, or a press that was too cold (below 18 C) so the propionic culture never woke up, or too much salt killing it outright.

Fix — Boil and re-salt the brine to 18-20% between batches, press at 20-22 C for the first six hours, and keep the salt under 1.6% for eye-forming styles.

Misread surface mould seen this make

Signal — A grey-green or black fuzzy patch on a rind that was supposed to be white or orange, or blue speckling on a hard cheese.

Cause — Wild Penicillium and Cladosporium from a cave with moving air and standing humidity. Also from brushing a good rind with a damp, dirty brush.

Fix — Distinguish before you discard: white felt and orange smear are wanted, green fuzz on a hard rind is surface only and rubs off with 3% brine. Black patches that pit the paste mean the wheel is lost.


Four things to carry forward

  1. 1.2% thermophilic on sheep milk, 30 IMCU/litre, cook to 48 C
  2. Dry-salt 1.2% + 1.2% + 1.1% on days 1, 3 and 6
  3. Age at 14 C / 75% RH, the driest cave in this ledger
  4. Eight months for grating, five months if you want it on a board