Curd & Rind A home cheesemaking ledger: every make, every parameter, every rind.

Ledger / Hard / 2026-11-02

Mimolette: The Mite Rind, and What To Do When You Cannot Get Mites

The orange Mimolette rind is not dyed. It is the work of a flour mite that eats the surface and leaves a pitted, cratered crust behind. The mites are essentially impossible to obtain on purpose outside a French affineur, so this record gives the annatto-and-oil substitute and the honest difference between them.

Set 30′ 32 °C
Cut 10′ 8 mm
Scald 25′ 36 °C
Drain 30′ pH 6.3

Each segment is as wide as its share of the 95 minutes in the vat; the set segment carries the set temperature, the cut segment carries the cut size.

Salt and press drawer
Salt methodOlive oil rub
Brine22 %
Press25 kg × 12 h

Press ladder

  • 8 kg1 h
  • 16 kg4 h
  • 25 kg7 h

Oil plus a little salt every other week; the rind dries to a hard amber skin.

Cut face and rind figure: Mimolette: The Mite Rind, and What To Do When You Cannot Get Mites
The cut face is one irregular polygon whose vertex count is set by the 38% target moisture; the pores are countable negative space, and the rind arcs increase with the 240-day cave.

A tight make with a modest scald

0.5% mesophilic culture at 32 C, thirty minutes of ripening, 26 IMCU of animal rennet per litre, thirty-minute set. Cut to 8 mm, raise to 36 C over twenty-five minutes, and drain.

Mimolette is a firm, dense cheese with 38% moisture, so the press matters more than the cook. A light scald and a long press is the correct combination; the reverse gives a cheese that is dry at the outside and soft in the middle.

Twenty-two percent brine for twelve hours

Press at 8 kg for an hour, 16 kg for four hours, 25 kg for seven. Rest two days at 15 C, then brine at 22% and 12 C for three hours per kilo.

Dry the ball at 15 C for four days until the rind is firm enough that a fingernail leaves no mark. This drying step is what the mites need; they will not colonise a damp surface, and they will die out on one that stays wet.

Oil and annatto, and the honest caveat

Rub the rind with olive oil coloured with annatto seed, roughly 1 g of annatto per 100 ml of oil, every two weeks for eight months. The oil darkens it to a deep orange and the surface develops the fine cracking and shallow pits that people associate with Mimolette.

It is not the same cheese. A mite rind is thinner, more even, and the pitting goes deeper; the paste underneath loses slightly more moisture and ends up denser and more intensely flavoured. It is a good cheese either way, and the oil version is far more predictable in a home cave.

Thirteen degrees, 78%, eight months

Age at 13 C and 78% RH, turning twice a week. This is drier than most caves here; a Mimolette rind has to stay firm, and a damp cave turns it soft and sour.

At eight months it is firm and dense with a distinctly nutty, almost caramelised flavour and a long finish. Very young Mimolette at two months is springy and mild and is worth making a small ball of just to eat fresh, but it is a different experience entirely.


Aging parameters

MilkPasteurised cow milk 3.5% fat
CultureMesophilic 20–30 °C
RennetCalf rennet (animal) 26 IMCU/L
pH at drain6.3 target 6.1–6.5
Target moisture38 %
Cave temperature13 °C
Cave humidity78 %
Aging days240 days
Rind treatmentOlive oil rub
Yield3.8 kg

Pasteurised cow milk Hard 240 days


Defect diagnosis

Flagged on this make: Misread surface mould、Faulty eye formation

Bitterness not seen

Signal — A harsh, lingering bitter note at the back of the palate, strongest in the first three weeks and often fading after six.

Cause — Too much rennet for the set time, or a microbial coagulant with high protease activity, or a scald that never got past 38 C.

Fix — Cut the dose by 20% next make and hold the scald 2 C higher for 10 minutes longer. Bitter peptides are water-soluble, so a 12% brine for 24 hours pulls some out.

Rancidity not seen

Signal — Soapy, paint-like smell that hits before the cheese reaches the mouth. Sharp and unpleasant rather than merely strong.

Cause — Free fatty acids released by lipase, usually from raw milk that sat warm too long, or from rennet paste, or from a knife or cloth that carried old milk residue.

Fix — Chill milk to 4 C within two hours of milking and pasteurise anything older than 24 hours. Retire the cloth: boil it, do not just rinse it.

Faulty eye formation seen this make

Signal — Either no eyes where the style demands them, or a scatter of irregular slits and cracks instead of round, evenly spaced holes.

Cause — Coliform or yeast contamination from unsanitary brine, or a press that was too cold (below 18 C) so the propionic culture never woke up, or too much salt killing it outright.

Fix — Boil and re-salt the brine to 18-20% between batches, press at 20-22 C for the first six hours, and keep the salt under 1.6% for eye-forming styles.

Misread surface mould seen this make

Signal — A grey-green or black fuzzy patch on a rind that was supposed to be white or orange, or blue speckling on a hard cheese.

Cause — Wild Penicillium and Cladosporium from a cave with moving air and standing humidity. Also from brushing a good rind with a damp, dirty brush.

Fix — Distinguish before you discard: white felt and orange smear are wanted, green fuzz on a hard rind is surface only and rubs off with 3% brine. Black patches that pit the paste mean the wheel is lost.


Four things to carry forward

  1. 0.5% mesophilic at 32 C, 26 IMCU/litre, scald only to 36 C
  2. Press 25 kg for seven hours, brine at 22%
  3. Dry four days until a fingernail leaves no mark
  4. Oil with annatto every two weeks; age at 13 C / 78% for eight months