Curd & Rind A home cheesemaking ledger: every make, every parameter, every rind.

Ledger / Hard / 2026-10-25

Grana Padano: The Same Family, Two Degrees Cooler and Six Months Shorter

Grana Padano and Parmigiano are separated by a handful of parameters, and the most important is the cook temperature. Padano is cooked to 52 C rather than 55, which leaves slightly more moisture and makes a cheese that is ready at fourteen months instead of twenty-four.

Set 25′ 33 °C
Cut 15′ 5 mm
Scald 35′ 52 °C
Drain 30′ pH 6.1

Each segment is as wide as its share of the 105 minutes in the vat; the set segment carries the set temperature, the cut segment carries the cut size.

Salt and press drawer
Salt methodOlive oil rub
Brine24 %
Press35 kg × 18 h

Press ladder

  • 10 kg1 h
  • 22 kg5 h
  • 35 kg12 h

Oil plus a little salt every other week; the rind dries to a hard amber skin.

Cut face and rind figure: Grana Padano: The Same Family, Two Degrees Cooler and Six Months Shorter
The cut face is one irregular polygon whose vertex count is set by the 32% target moisture; the pores are countable negative space, and the rind arcs increase with the 420-day cave.

Twenty-five minute set and a 52 C cook

Raw milk, 1.5% thermophilic culture at 33 C, twenty-five minutes of ripening, 24 IMCU of calf rennet per litre, twenty-five minute set. Cut to 5 mm, rest ten minutes, then heat to 52 C over thirty-five minutes.

The two-degree difference matters more than it sounds. At 55 C you drive out enough water that the cheese needs two years to become edible; at 52 C it is 32% moisture and ready in fourteen months, with a slightly softer, less crystalline paste.

Brine at 24% for sixteen days

Press at 10 kg for an hour, 22 kg for five hours, then 35 kg for twelve. Rest two days at 15 C, then brine at 24% and 12 C for sixteen days for a 3.2 kg wheel, turning every second day.

Twenty-four percent is slightly weaker than the Parmigiano brine and the soak is shorter, both because the paste is more open and will take salt faster. Going the full Parmigiano route here gives a rind that is too salty against the milder paste.

Fifteen degrees, and oil rather than brushing

Age at 15 C and 78% RH. Rub the rind with olive oil every three weeks for the first four months, then every six weeks. Do not scrape or brush the rind: a Grana rind is meant to stay intact, and the oil keeps it supple enough not to crack along the rim.

The wheel should lose about 8% of its weight over the first year. Faster than that and the cave is too dry and you will get rim cracks; slower and the surface moulds will take hold under the oil.

Fourteen months, and the crack test

At fourteen months the cheese is firm and granular with visible crystals and a mild, savoury, slightly lactic flavour. It is the version most people actually prefer for eating raw.

At twenty months it is darker, sharper and more crystalline, closer to a Parmigiano. Both are good. Tap the wheel with a small hammer before you commit to a long age: a clean ring means it is sound, a dull thud means there is a crack and the wheel will not age well.


Aging parameters

MilkRaw cow milk 3.9% fat
CultureThermophilic 38–45 °C
RennetCalf rennet (animal) 24 IMCU/L
pH at drain6.1 target 6.1–6.5
Target moisture32 %
Cave temperature15 °C
Cave humidity78 %
Aging days420 days
Rind treatmentOlive oil rub
Yield3.2 kg

Raw cow milk Hard 420 days


Defect diagnosis

Flagged on this make: Bitterness、Faulty eye formation

Bitterness seen this make

Signal — A harsh, lingering bitter note at the back of the palate, strongest in the first three weeks and often fading after six.

Cause — Too much rennet for the set time, or a microbial coagulant with high protease activity, or a scald that never got past 38 C.

Fix — Cut the dose by 20% next make and hold the scald 2 C higher for 10 minutes longer. Bitter peptides are water-soluble, so a 12% brine for 24 hours pulls some out.

Rancidity not seen

Signal — Soapy, paint-like smell that hits before the cheese reaches the mouth. Sharp and unpleasant rather than merely strong.

Cause — Free fatty acids released by lipase, usually from raw milk that sat warm too long, or from rennet paste, or from a knife or cloth that carried old milk residue.

Fix — Chill milk to 4 C within two hours of milking and pasteurise anything older than 24 hours. Retire the cloth: boil it, do not just rinse it.

Faulty eye formation seen this make

Signal — Either no eyes where the style demands them, or a scatter of irregular slits and cracks instead of round, evenly spaced holes.

Cause — Coliform or yeast contamination from unsanitary brine, or a press that was too cold (below 18 C) so the propionic culture never woke up, or too much salt killing it outright.

Fix — Boil and re-salt the brine to 18-20% between batches, press at 20-22 C for the first six hours, and keep the salt under 1.6% for eye-forming styles.

Misread surface mould not seen

Signal — A grey-green or black fuzzy patch on a rind that was supposed to be white or orange, or blue speckling on a hard cheese.

Cause — Wild Penicillium and Cladosporium from a cave with moving air and standing humidity. Also from brushing a good rind with a damp, dirty brush.

Fix — Distinguish before you discard: white felt and orange smear are wanted, green fuzz on a hard rind is surface only and rubs off with 3% brine. Black patches that pit the paste mean the wheel is lost.


Four things to carry forward

  1. 1.5% thermophilic, 24 IMCU/litre, 25-minute set at 33 C
  2. Cook to 52 C, not 55: 32% moisture and ready at 14 months
  3. 24% brine for sixteen days on a 3.2 kg wheel
  4. Oil the rind every three weeks; tap-test before a long age